If you still get letters drawn over each other you could have your quick move settings too fast or your might have loose belts. Always home your machine before starting a job and you should get proper movement. ![]() The very next thing I would do is manually move the machine forward and to the right a little and then mark 20mm on a piece of paper and set the machine to move 10mm at a time and make sure the laser moves 20mm to the right when commanded to move 20mm and then make sure it moves 20mm forward when commanded to move 20mm forward. You should go in and edit your machine definition and select the top left(rear left) and hit the home button after reconnecting and see that it goes the the left rear. ie 0,0 is your home position and your origin. The origin on the K40 is usually the left rear and that is where the home switches are. I made no adjustments, I didn’t touch the program or the work piece. This time the K40 goes to the top right and spells MILA out properly. Without adjusting anything, I hit the start button again. The K40 goes to the bottom right and writes MILA with all the letters on top of one another (See first photo below). I ran the word MILA in the middle of my work space. For example, I wanted to do some test burns for a dog tag I would like to make my new puppy.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |